Duo therm air conditioning heat strip
With the switch in the OFF position, you should not have continuity between terminal L1 and any other terminals. For the correct amount of R refrigerant charge, check the data plate of the air conditioner you are working on. If the correct system information does not show, check configuration - Section D on page 60 before control is replaced. Terminal T2 is a black wire and is Reversing Valve circuit. If the blue low side gauge is well below 10 inches of vacuum, continue the evacuation for at least 40 to 45 minutes or until you have a dry system microns or less on a vacuum thermistor gauge.
Search by Keyword
Dometic 3315450.000 Air Conditioner Heat Strip Kit for Brisk II Ducted Models
Back To Top Showing 1 - 24 of Locate the leak and correct it before proceeding. The freeze control is NOT used. The operating instructions can change from one model to another. Some units are 2-speed. To check the relay, use a voltmeter. This completes connections for one end of the cable.
Dometic Brisk Air II & Penguin II AC Non-Ducted Heat Strip - Boat and RV Accessories
Next, check for continuity on each wire, such as Pin 1 to Pin 1, then Pin 2 to Pin 2, etc. Continuity Terminal 2 is white wire and is run circuit to compres- means the fuse is good. The heat removed from the refrigerant is expelled to the inside air. At this point, the fan will either: a. Note: Freeze control is not used on heat pump coils, some Note: Freeze control is not used on heat pump coils.
If a furnace is to be connected, wires must be run from the furnace to the Air Conditioner. Mode Selector Button D. If it is used with rooftop heat pumps, it can cause premature shutoff of the compressor. Make note of the wire size and compare it to the chart for wire sizing. Terminal 7 is a red wire and is low fan circuit. The thermostat or remote sensors must be placed in a location with good air movement. All discharge air ducts must be properly insulated to prevent condensation from forming on their surfaces or adjacent surfaces during operation of the air conditioner or heat pump.